2 Cell Battery Replacement for ML-310ES DeNova Detect Gas Alarm
- 2-cell replacement battery configuration
- Designed for the DeNova Detect ML-310ES natural gas alarm
- Direct replacement for compatible alarm battery assemblies
- Replacement part number: CR17450E-R
- Do not remove the plastic surrounding the battery pack.
2 Cell Battery Replacement for ML-310ES DeNova Detect Gas Alarm Product Description
The DeNova Detect CR17450E-R is a 2-cell replacement battery designed for the DeNova Detect ML-310ES natural gas alarm. Use this replacement battery to replace the existing battery in compatible ML-310ES alarms when battery replacement is required. Verify the model number of your alarm before ordering to ensure proper compatibility.
- Open the battery compartment. Locate the battery compartment cover on the back of the DeNova Detect ML-310ES Gas Alarm. Place both thumbs on the area of the cover where the battery cover hooks snap into place.
- Remove the battery cover. Push down firmly where the cover snaps into place while sliding the cover out. Some force may be required.
- Connect the replacement battery. Insert the lithium battery harness connector into the Gas Alarm receptacle. Do not remove the plastic wrap surrounding the battery pack.
- Check the connector orientation. The battery connector has a large notch that should face upward when installed correctly. The connector is designed to fit in only one orientation.
- Confirm the connection. When the battery connector is installed properly, a small portion of the connector will remain visible outside of the receptacle.
To replace the battery in your ML-310ES natural gas detector:
- Open the battery compartment on your natural gas alarm.
- Carefully disconnect and remove the depleted battery assembly.
- Connect the new CR17450E-R 2-cell battery pack to the connector terminal.
- Important: Do not remove the clear protective plastic wrap surrounding the 2-cell battery pack. It is required for insulation and proper housing alignment.
- Close the compartment and press the Test/Hush button to confirm your gas leak alarm is operational.
